Alutech LG-600F-868 Manuel D'installation Et D'utilisation page 24

ADjUSTMENT
The setup is similar to that in item 5 of Table 6,
but for program 'P2' and function 'F6' .
ATTENTION!
10.1
The button, pressed during the programming,
will send command OPEN (OP), and the next
buttons—command STOP (STOP), CLOSE (CL)
and 'light lamp (LL)' control command
P2-F7—Identifying the remote-control number
11
in the memory
Press and hold
11.1
for about 5 secs to enter the
programming mode
Using and
11.2
select program 'P2' on the
menu
11.3 Press
Using and
11.4
select function 'F7' on the
menu
11.5 Press
'rc' is shown on the display,
which means that a signal
11.6
from the remote control is
expected
Press the control button on
11.7 the remote control three
times
The display will automatically
show the number of the
11.8
remote control in the drive
memory
In three seconds the switch
to the waiting mode for the
signal from the next remote
control will take place.
11.9
To exit the programming
mode press
times or wait for 15 seconds
P2–F8—Delete the remote control based
on its code
12
This option is used if information for the remote-
control number in the drive memory is
not available
22
three
LEVIGATO DRIVES (LG SERIES)
Press and hold
12.1
for about 5 secs to enter the
programming mode
Using
12.2
select program 'P2' on the
menu
12.3 Press
Using
12.4
select function 'F8' on the
menu
12.5 Press
'rc' is shown on the display,
which means that a signal
12.6
from the remote control is
expected
Press the control button on
12.7 the remote control three
times
The display will automatically
show the number of the
12.8
remote control in the drive
memory
Press
disappear from the display,
this means that the remote
12.9
control with the selected
number is deleted from the
memory
In three seconds the switch
to the waiting mode for the
signal from the next remote
control will take place.
12.1
To exit the programming
mode press
for 15 seconds
P2–F9—Delete the remote control based on its
number in the memory
13
This option is used if the remote control is absent,
but information for the remote-control number
in the drive memory is available
Press and hold
13.1
about 5 secs to enter the
programming mode
| LEVIGATO ANTRIEBE (SERIE LG)
and
and
. A dot will
or wait
for
| COMMANDES LEVIGATO (SERIE LG)