Operation; Switching On; Contrast Methods - Leica DMI3000B Mode D'emploi

8. Operation

8. Operation

8.1 Switching on

When using a gas discharge lamp, the ebq 100
external supply unit must be turned on separately
(104.1).
Leica DMI3000 B:
• Switch on the microscope's power at the
On/Off switch. The signal lamp is lit when the
instrument is ready. (Continue with Chapter 8.2

Contrast Methods)

Leica DMI4000 B and Leica DMI6000 B:
• Switch on the power of the electronics box
at the On/Off switch (105.1). The signal lamp
(105.2) is lit green when the unit is ready.
All motorized microscope components will
then run through an initialization phase.
Fig. 104 Front panel of ebq 100 supply unit
1 Power switch
2 Lamp status
1
82
2
Note:
If a PC is connected, switch on the electronics
box fi rst, and then the computer.
All motorized microscope components will then
run through an initialization phase.
Note:
In the case of faulty initialization („Init Error"
message on LeicaScreen), see Troubleshooting
chapter, → p. 106.
Fig. 105 front side Leica CTR6000
1 On/Off switch
2 Signal lamp
3 Warning:Regard safety notes!
1
2
3