Threading in the power and antenna cables
Fig. 11: Threading in the power and antenna cables
5.
From below, thread the power cable and – if
required – the antenna cable through the cut-
out in the threaded rod
in the baseplate
the protective cover with cable opening
© sonoro audio GmbH 2016
, through the opening
and through the cut-out in
Attaching the stand tube
Fig. 12: Attaching the stand tube
.
6.
Position the stand tube
opening facing upwards and place it on the
threaded rod
7.
Make sure that the milled opening in the stand
tube
cable routing underneath the tube.
i
The stand tube
power and antenna cables.
8.
Route the power cable and, if required, the
antenna cable through the milled opening in the
stand tube
9.
Place the protective cover without cable
opening
with the milled
.
is on the same side as the cut-outs for
acts as a cable duct for the
.
on the threaded rod
.
85