Activating/Deactivating The Alarm; Switching Off The Alarm Sound; Snooze Settings - Sonoro sonoroHIFI SO-510 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

10. Press
to confirm the selected volume.
ð The alarm volume is set. The display shows
the alarm repetition frequency „Daily" .
Setting the alarm repetition frequency
11. Turn
to set the desired alarm repetition fre-
quency. You can choose between the following
settings:
n „Once"
n „Daily"
n „Weekends"
n „Weekdays"
12. Press
to confirm the selected repetition fre-
quency.
ð The alarm repetition frequency is set. The
alarm settings are now complete.
7.2

Activating/deactivating the alarm

i
When a set of headphones is connected, the alarm
will only sound through the headphones. Make
sure there are no headphones connected if you
want to activate the alarm.
Activating the alarm
1.
To activate the alarm, briefly press
ð The display shows
vated.
Deactivating the alarm
1.
To deactivate the alarm, press
is no longer displayed. The alarm is
ð
deactivated.
7.3

Switching off the alarm sound

Prerequisite: The alarm sounds.
© sonoro audio GmbH 2016
or
.
. The alarm is acti-
/
again.
1.
Press one of the following buttons to switch off
the alarm:
/
n
n
/
n
ð The alarm stops sounding and is switched
off.
i
If you want the alarm to sound again a set time
after it has been switched off, use the Snooze
function.
Ä „Snooze settings" on page 107
i
When the alarm has stopped sounding, the set
alarm is activated for the next day (unless the "
Once" alarm repetition option has been selected).
Ä „Setting the alarm" on page 106
7.4

Snooze settings

Snooze is a wake-up function that causes the alarm to
go off again after a set time interval. You can prede-
fine this time interval or set it after the first alarm
signal has gone off.
Setting the Snooze time interval
1.
Standby mode: Briefly press
Alternatively:
If the device is on: Press and hold
ð The display shows the „Snooze" setting.
2.
Turn
until the display shows the required
time interval for the snooze function.
3.
Press
to confirm the selected time interval.
ð The time interval is set.
.
.
107

Publicité

Table des Matières
loading

Table des Matières