Camille Bauer KINAX N702 Mode D'emploi page 13

Capteur d’inclinaison avec système de pendule amorti par huile
Masquer les pouces Voir aussi pour KINAX N702:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Programming instruction
Control panel: The inclination transmitter is programmable
via keyboard. The keyboard is visible after
opening the blue cover.
LED
Standard programming I
(initial and fi nal position)
Application:
The measuring range (e.g. 4 - 20 mA) is
between two fi xed tilt angles (e.g. – 10° to
+ 60°). The fi nal position can be programmed
via keystroke after mounting the KINAX on
the aligned object. The instrument can be
electrically connected in any position.
y
+45°
1. Programming mode «on»
press quickly: 2x red (R; R; ...LED on)
2. Put transmitter into initial position
Program 0%
press quickly: 1x left green (0%; ...LED blink 1 s)
3. Put transmitter into fi nal position
Program 100%
press quickly: 1x right green (100%)
4. Switch sense of rotation (optional)
press quickly: 1x red (R; ...LED blink 1 s)
5. Mode «off»
press quickly: 2x red (R; R; ...LED blink 1 s, LED off)
14
green
buttons
0%
100%
R
red
button
+60°
20 mA
-10°
–10°
4 mA
Standard programming II
(Zero position programming)
Application:
The measuring range (e.g. 4 - 20 mA) is ad-
justed by factory and symmetrically split (e.g.
± 45°). The range is calibrated on factory side
and should not be changed. The initial posi-
tion can be programmed via keystroke after
mounting the KINAX on the aligned object.
The instrument can be electrically connected
in any position. The adjusted measuring range
is symmetrical and starts from zero position,
e.g. the zero position corresponds always to
12 mA.
1. Programming mode «on»
press quickly: 2x red (R; R; ...LED on)
2. Programming zero position
press quickly: 1x left green & right green (0% & 100%;
...LED blinks 1 s)
3. Switch sense of rotation (optional)
press quickly: 1x red (R; ...LED blinks 1 s)
4. Mode "off"
press quickly: 2x red (R; R; ...LED blinks 1 s, LED off)
x
To restore the factory settings (RESET):
1. Programming mode "on"
press quickly: 2x red (R; R; ...LED on)
2. Keep red key pressed (> 3 s)
(R; ...LED blinks 1 s; LED off)
+45°
-45°
Electrical connected
in any position

Publicité

Table des Matières
loading

Table des Matières