RIB NORMAL Mode D'emploi page 29

POINT A -
CONTROL PANEL FEATURES
J4
J1
S3
TR2
J9
J5
J2 J3
DIP12 ON to instal the PARK 230V control panel
on Normal barriers.
J1
J2
J8
J3
J7
J6
J4
J5
J10
J6
J7
J8
J9
J10
S3
TR2
29
29
L-N Main power supply 230Vac 50/60Hz upon request)
COM Common contact
LSC Closing limit switch contact (NC)
LSO Opening limit switch contact (NC)
LSSC Not used
LSSO Not used
TLC Vehicle presence signal (NO) (only when switched to
PARK mode)
PHOT. NC Photocells contact (NC)
EDGE NC Safety strip contact (NC)
COM Common contact
D+ TEST Safety strip self-test power supply +12Vdc 500mA
max
D+ Accessories power supply +12Vdc 500mA max
D- Accessories power supply -12Vdc 500mA max
OPEN 2 Barrier opening button 2 contact (NO) (only when
switched to PARK mode)
SIGNAL Barrier open signal 12Vdc
Buzzer - Acoustic signal connection (12Vdc max 200
mA)
AERIAL Radio antenna
Blinker (max 40W)
U - MOTOR Motor common connection
V-W - MOTOR Motor inverters and condenser connection
OK CLOSE Immediate closure command contact (only when
switched to PARK mode)
OPEN 1 Open1 button contact (NO)
CLOSE Close button contact (NO)
STOP Stop button contact (NC)
K BUTT. Single pulse button (NO)
COM Common contact (common line for all the commands
and safety inputs)
PROBE Heating probe connection terminal block (code
ACG4666 optional)
RADIO Connector for radio external receiver, 12Vdc supply
AUX. ATT. Card 1 relay connector (code ACQ9080) for
management of courtesy light or boom arm locking
magnet
Card 3 relay connector (code ACQ9081) for
management of courtesy light or boom arm locking
magnet and traffic lights.
SW PARK DO NOT TOUCH THE JUMPER!
IF REMOVED THE OPERATOR DOES NOT
FUNCTION!
SW RADIO DO NOT TOUCH THE JUMPER!
IF REMOVED THE RADIO SYSTEM DOES NOT
FUNCTION!
PROG. Programming button
TRIMMER LOW Not available
SPEED
G
B