Publicité
Les langues disponibles
Les langues disponibles
The picture shows the GR-12+3xG HoTT receiver, which is installed as standard.
Caution: it is essential not to alter the position of the receiver. The receiver
must be firmly fixed to the fuselage. If this is not the case, the gyro's self-
stabilising function may not operate correctly. The longitudinal (fore-and-aft)
axis of the receiver case must line up accurately with the model's longitudinal
centreline. The receiver should now be bound to the transmitter. Connect the aileron
servo leads to the Y-lead, which is already plugged into the receiver. Ensure that the
plugs are inserted to their full depth. Temporarily fix the wing to the fuselage using
the bolt (11) so that you can test the working systems.
The photo shows the wing panels locked together using the retaining components
(11), as seen from the rear. In this position press the bolt into place until it engages,
then twist it to the left through 90° .
Attention: pull on the wing before every flight to check that it is firmly attached
to the fuselage. If you overlook this, the wing might come adrift in flight, and
part company from the fuselage; this will invariably end in a crash. Please bear
in mind that the model could then hurt you or other people in the vicinity,
possibly with very serious consequences.
GRAUPNER/SJ GmbH D-73230 KIRCHHEIM/TECK GERMANY
Modifications reserved. No liability for printing errors.
08/2014
6
Publicité
