NSK Ti-Max NLX nano Manuel D'utilisation page 5

3. Operating Control Box
CAUTION
· Be sure that there is no air or water coming from Turbine Hose when connecting to control box.
· Hand tighten the Nut properly without unnatural force, when you plug into Turbine Hose Connector and Motor Cord
Connector.
3-1 Connect the handpiece tubing from the delivery unit you are
using
Fit the Turbine Hose Plug of the delivery unit to the Turbine Hose
Connector piping and tighten completely. (Fig. )
CAUTION
· Do not use it other than the hose which we appointed.
· Do not use wet or contaminated air.
· Install an air filter if necessary. Blow out the lines before
installation.
3-2 Connecting the Motor
Connect the motor by aligning the Motor Cord Plug and insert
firmly. Tighten it completely. (Fig. 2)
3-3 Connecting the AC adapter
Insert the AC adapter plug into the AC adapter connector before
pugging into wall outlet. (Fig. 3)
CAUTION
Never use the AC Adapter for other than the Control Box of this
product.
3-4 Connecting the Power Cord
Insert the Power Cord into the Inlet of AC Adapter. (Fig. 4)
Motor Cord Connector
4
Turbine Hose Connector
Turbine Hose Plug
Motor Cord Plug
AC Adaptor Plug
Inlet
AC Cord
Fig.
Fig.2
Fig.3
Fig.4