Maintenance And Inspection - Metabo HPT NR 90AF Manuel D'instructions Et De Sécurité

Nose cap can be removed from the push lever using a
screwdriver or thin rod.
Screwdriver
NOTE: The information contained in this Manual is designed to assist you in the safe maintenance of the Nailer.
Some illustrations in this Manual may show details or attachments that diff er from those on your own Nailer.

MAINTENANCE AND INSPECTION

Read section titled "SAFETY" (pages 4 – 8).
● Disconnect air hose and remove all nails
from Nailer when:
1) doing maintenance and inspection;
and
2) clearing a jam.
1. Clearing a jam
Remove a jammed nail in the following order:
1 DISCONNECT AIR HOSE.
2 Insert a rod into the outlet.
Tap the rod with a hammer.
Hammer
Rod
Outlet
Push lever
Nose cap
MAINTENANCE
WARNING
Disconnect
1
air hose
3 Remove the jammed nail with a slotted screw
driver.
4 In case of frequent jam, contact a metabo HPT
authorized service center.
2. Inspecting the magazine
1 DISCONNECT AIR HOSE.
2 Clean the magazine. Remove paper chips or wooden
chips which may have accumulated in the magazine.
Lubricate it with metabo HPT pneumatic tool lubricant.
Cloth
CAUTION
● Check that the nail feeder slides smoothly by
pulling it with fi nger.
If not smooth, nails can be driven at an irregular
angle and hurt someone.
English
1
Disconnect
air hose
19