Standard Accessories; Optional Accessories; Applications; Before Operation - Metabo HPT NR 90AF Manuel D'instructions Et De Sécurité

STANDARD ACCESSORIES

1 Safety glasses ..........................................................1

OPTIONAL ACCESSORIES

○ Single sequential actuation mechanism kit (Code No.
888781)
○ Nose cap (Code No. 886401)
○ Pneumatic Tool Lubricant
.8 oz. (25 cc) oil feeder (Code No. 877153)
4 oz. (120 cc) oil feeder (Code No. 874042)
1 quart (1 ltr) can (Code No. 876212)
NOTE: Accessories are subject to change without any
obligation on the part of metabo HPT.

APPLICATIONS

○ Floor and wall framing.
○ Truss build-up, Window build-up.
○ Subfl ooring and roof decking.
○ Wall sheathing.
○ Mobile home and modular housing construction.

BEFORE OPERATION

Read section titled "SAFETY" (pages 4 – 8).
Make sure of the followings before operation.

WORKING ENVIRONMENT

● No fl ammable gas, liquid or other fl ammable
objects at worksite.
● Clear the area of children or unauthorized
personnel.
AIR SUPPLY
● NEVER use reactive gases or
1
... sold separately
WARNING
DANGER
other bottled
Explosion may occur.
● Never connect Nailer to pressure which
potentially exceeds 200 psi (13.7 bars 14 kgf/cm
if a regulator fails.
● Never use non relieving coupler on Nailer.
1. Power source
○ Use only clean, dry, regulated compressed air as a
power source for this Nailer.
○ Air compressors used to supply compressed air to
this Nailer must comply with the requirements of
the latest version of ANSI Standard B 19.3 "Safety
Standard For Compressors For Process Industries".
○ Moisture or oil in the air compressor may accelerate
wear and corrosion in the Nailer.
Drain daily.
2. Filter-Regulator-Lubricator
○ Use a regulator with a pressure range of 0 – 120 psi
(0 – 8.3 bar 0 – 8.5 kgf/cm
○ Filter-regulator-lubricator units supply an optimum
condition for the Nailer and extend the Nailer life.
These units should always be used.
Filter ........ The fi lter removes moisture and dirt mixed
Regulator ... The regulator controls the operating
Lubricator... The lubricator supplies an oil mist to the
Nailer
Side
gases.
3. Air hose
Compressed air supply hoses shall have a minimum
working pressure rating equal to or greater than the
pressure from the power source if a regulator fails,
or 150 psi (10.4 bar 10.6 kgf/cm
greater.
WARNING
).
2
in compressed air.
Drain daily unless fi tted with an automatic
drain.
Keep the fi lter clean by regular maintenance.
pressure for safe operation of the Nailer.
Inspect the regulator before operation to
be sure it operates properly.
Nailer.
Inspect the lubricator before operation to
be sure the supply of lubricant is adequate.
Use metabo HPT pneumatic tool lubricant.
Regulator
Lubricator
English
)
2
Compressor
Side
Filter
), whichever is
2
11