Cleaning Instructions; Important Cleaning Points; Inactivity - Saeco MEGACOLD L Notice Originale

MEGACOLD L– Issue 01
ATTENTION: These operations must be carried out by personnel with practical
experience of the apparatus, since safety and hygiene are involved
To assure optimal functioning of the vending machine over time, adequately and periodic maintenance is
necessary. This chapter is dedicated to maintenance operations and their frequency, which must in any case
be considered indicative since they depend on various factors such as the type of products used, the climate
conditions and in particular the humidity, etc. This chapter does not give an exhaustive description of all the
maintenance operations. All cleaning operations must be carried out after cutting off the electricity supply to
the vending machine. Under no circumstances may direct jets of water and/or pressurised water be used to
wash the vending machine. To avoid the risk of rust or chemical aggression in general, the stainless steel
and painted surfaces must be kept clean.
Switch off the machine by means of the main switch and pull out the power plug. Do not
wash the vending machine with direct jets of water and/or pressurised water.

11.1 IMPORTANT CLEANING POINTS

Use cleaning products adhering strictly to the doses indicated on the label. Do not use too aggressive
detergents since they could damage certain parts; the manufacturer declines all responsibility for damages
caused by the incorrect use of such detergents or by the use of toxic agents.
With sanitising
products (chlorine
detergents or similar)
With a vacuum
cleaner or with
compressed air
If this operation is not performed correctly, the refrigeration system could be
seriously damaged.
•
NEVER IMMERSE THE COIN MECHANISM IN WATER
•
DO NOT USE ABRASIVE MATERIALS
•
DO NOT USE SPRAY LUBRICANTS

11.2 INACTIVITY

If long periods of machine inactivity are expected, it is recommended to adopt adequate precautions to
prevent dangerous situations when the machine is re-started; for long periods, it is intended complete
machine inactivity exceeding one month.
For long resting period, it is necessary:
•
To clean the machine thoroughly and to dry it;
•
To check carefully for damaged or worn parts and to replace them;
•
To check that the screws and bolts are securely tightened;
•
To cover the machine after having stored it in a protected environment.
To re-set the machine at work, comply with the instructions given in the paragraph "Installation" of this
manual and pay particular attention if food products are to be sold (see paragraph "Use of the vending
machine for the sale of food products").
11

CLEANING INSTRUCTIONS

Interior of body (trays area), trays, display window.
Any residues of detergent, disinfectant or food must be
removed with a damp sponge before the machine is
switched on again.
Remove dirt from the condenser.
Check that there is a passage for air between the front
and the back of the condenser. Always clean the interior of
the body after this operation.
47
Every time the
machine is filled up
or, in any case, every
5 days
monthly
E
N
G
L
I
S
H