Saeco MEGACOLD L Notice Originale page 86

36
Command 34 Coin inhibition with exact amount:
This command blockes the acceptance of particular coins in case of small return, i.e. when the display views
the message "Insert only exact amount".
Command 35 Coin level message exact amount:
A value between 0 and 15 representing the number of coins to be added to the minimum level fixed in the
coin return tubes - can be programmed, in order to quit the "exact amount" condition.
Command 36 Equation exact amount:
It represents the combination of empty spaces in the tubes so that the message exact amount can be
activated. Here is a list of possible combinations:
0 = A or (B e C)
3 = A and (B o C)
6 = A or B or C
9 = only B e C
E
12 = only C
N
G
Command 37 Enabling credit card reader:
L
The functioning of the credit card will be enabled by setting this command to 1.
I
S
Command 38 Emptying of change giving tubes:
H
This command is used to inventory the coins in the tubes of the coin mechanism. To obtain the allotment
from tube 1 (coins of lower value) proceed as follows:
1. Programming mode, display views........................................................................................... Command 00
2. Dial 38 and press ENTER, display views ................................................................................... Tube no. 00
3. Dial 1 and press ENTER,
The coin mechanism starts giving out coins from the chosen tube until the release of pushbutton B.
Command 39 Filling up of change giving tubes:
Proceed as follows:
1. Programming mode, display views........................................................................................... Command 00
2. Dial 39 and press ENTER
3. Insert the coins into the coin mechanism.
4. Press again pushbutton ENTER
N.B. If the procedure is not correctly carried out, you can find wrong values in commands 09 - 10.
1 = A and B and C
4 = only A
7 = only A and C
10 = only B
MEGACOLD L – Issue 01
2 = only A and B
5 = only A or B
8 = only A or C
11 = only B or C