Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Replacing the Lamp and the Filters
When the lamp reaches the end of its life, the Lamp indicator in the cabinet will blink red and the message "THE LAMP
HAS REACHED THE END OF ITS USABLE LIFE. PLEASE REPLACE THE LAMP. USE THE SPECIFIED LAMP
FOR SAFETY AND PERFORMANCE." will appear (*). Even though the lamp may still be working, replace the lamp to
maintain the optimal projector performance. After replacing the lamp, be sure to clear the lamp hour meter. (→ User's
Manual: "Menu Descriptions & Functions [RESET]")
CAUTION
•
DO NOT TOUCH THE LAMP immediately after it has been used. It will be extremely hot. Turn the projector
off and then disconnect the power cord. Allow at least one hour for the lamp to cool before handling.
CAUTION
•
Contact your sales or service representative to clean or replace parts for a projector that is installed on a
ceiling.
• Do not attempt to clean or replace parts for a projector that is installed in a high location on a ceiling. Doing
so may cause it to fall down, resulting in an injury.
• Do not open the lamp cover of a projector that is installed on a ceiling. Doing so may cause the lamp cover
to fall down. If the lamp is broken, pieces of glass may fall and cause an injury.
CAUTION
•
DO NOT REMOVE ANY SCREWS except one lamp cover screw and two lamp unit screws. You could
receive an electric shock.
CAUTION
•
Be sure to always use a dedicated replacement lamp that is new when replacing the lamp. If you use a lamp
that is not dedicated, it may result in an explosion and injury.
CAUTION
•
What to do if a lamp has exploded
• If the lamp explodes, remove the power cord from the product, leave the room while making sure it is thor-
oughly ventilated.
• If the lamp explodes and you think that you have gotten glass particles or mercury vapor in your eyes or
have inhaled either, contact a doctor immediately.
• Clean up the area around the product completely while being careful not to get injured from any broken glass
pieces.
• Throw away any food that was near the product.
• Ask your service representative to replace the lamp and inspect the product.
•
To order the replacement lamp, specify your lamp type.
Replacement lamp:
Replacement Lamp Type12
The replacement lamp comes with fi lters.
•
Do not break the glass on the lamp unit.
Keep fi nger prints off the glass surface on the lamp unit. Leaving fi nger prints on the glass surface might cause
an unwanted shadow and poor picture quality.
12
Publicité
Table des Matières
