Safety Labels Of This Machine - Ricoh PJ WX5361n Informations Importantes

2. POWER OFF ON NO SIGNAL (Factory preset: 20 minutes)
To control the projector from an external device, select [OFF] for [POWER OFF ON NO SIGNAL].
NOTE:
• When [20 MIN.] is selected for [POWER OFF ON NO SIGNAL], you can enable the projector to automatically turn off in 20 minutes
if there is no signal received by any input or if no operation is performed.

Safety Labels of This Machine

1 Do not look into the lens while the projector is on. Serious damage to your eyes could result. Do not use any other
object than the projector's sliding lens cover to cover the lens while the projector is on. Doing so can cause the
object to get extremely hot, and possibly resulting in a fi re or damage due to the heat emitted from the light output.
2 Do not try to touch the ventilation outlet on the left front (when seen from the front) as it can become heated while
the projector is turned on and immediately after the projector is turned off. Parts of the projector may become tem-
porarily heated if the projector is turned off with the Power button or if the AC power supply is disconnected during
normal projector operation. Use caution when picking up the projector.
3 Do not remove any screws except the lamp cover screws. Do not block or cover the vents.
4 To replace the lamp, fi rst unplug the power cord then wait for more than 1 hour.
The lamp might be broken. Be careful of pieces of broken glass.
3 1
4
11
2