Fujitsu Oracle SPARC M10 Guide D'installation page 208

POST Sequence 19 Sector Cache
POST Sequence 1A SX
POST Sequence 1B RT
POST Sequence 1C RT/SX NC
POST Sequence 1D RT/SX Interrupt
POST Sequence 1E RT/SX Barrier
POST Sequence 1F Error CPU Check
POST Sequence 20 System Configuration
POST Sequence 21 System Status Check
POST Sequence 22 Start Hypervisor
POST Sequence Complete.
Post APL Hypervisor version: @(#)Hypervisor 0.19.4 2012/09/24 18:12
:
(snip)
:
SPARC M10-1, No Keyboard
Copyright (c) 1998, 2012, Oracle and/or its affiliates. All rights reserved.
OpenBoot 4.34.0, 31232 MB memory available, Serial #268828936.
[ SPARC M-Series support 1.1.0 ]
Ethernet address b0:99:28:9a:98:7, Host ID: 90060108.
/pci@8000/pci@4/pci@0/pci@0/scsi@0
FCode Version 1.00.56, MPT Version 2.00, Firmware Version 13.00.66.00
When disks of 600 GB are mounted on slot#0 and slot#1
Target a
Unit 0 Disk TOSHIBA MBF2600RC 3706 1172123568 Blocks, 600 GB
SASDeviceName 50000394281b6190 SASAddress 50000394281b6192 PhyNum 0
Target b
Unit 0 Disk TOSHIBA MBF2600RC 3706 1172123568 Blocks, 600 GB
SASDeviceName 50000394281b5a44 SASAddress 50000394281b5a46 PhyNum 1
Target c
Unit 0 Encl Serv device FUJITSU NBBEXP 0d32
SASAddress 500000e0e04902fd PhyNum 14 /pci-performance-counters@8100
:
(snip)
:
/pci@8100/pci@4
/pci@8100/pci@4/pci@0
/pci@8100/pci@4/pci@0/pci@9
/pci@8100/pci@4/pci@0/pci@1
/pci@8100/pci@4/pci@0/pci@0
/pci@8100/pci@4/pci@0/pci@0/network@0,1
/pci@8100/pci@4/pci@0/pci@0/network@0
/pci@8000/pci@4
/pci@8000/pci@4/pci@0
When an FCoE card is mounted on the PCI slot#0
/pci@8100/pci@4/pci@0/pci@0
/pci@8100/pci@4/pci@0/pci@0/QLGC,qlc@0,3
/pci@8100/pci@4/pci@0/pci@0/QLGC,qlc@0,2
/pci@8100/pci@4/pci@0/pci@0/ethernet@0,1
Guide d'installation des systèmes SPARC M10 ･ Mars 2013
196