Error Codes - Saeco Primea Touch Plus Mode D'emploi

44

ERROR CODES

GUIDE MESSAGE THAT APPEARS
restart the machine
call assistance
insert drip tray
close coffee bean container
add ground coffee
insert brew group
insert dreg drawer
empty dreg drawer
close side door
refill water tank
empty drip tray
insert the milk container
prime the machine
circuit priming failure
the descaling cycle has not been completed
correctly
milk rinsing
milk cleaning
HOW TO REMOVE THE MESSAGE
Turn off and after 30 minutes turn the machine on again
to restore normal operation.
Problem that requires the intervention of the customer
service center.
Insert drip tray under the brew group.
Close the coffee bean hopper cover to be able to brew
any beverage.
This message guides the user when, in the customized
beverage programming, the use of this type of coffee has
been chosen.
Insert the brew group in its place.
Insert the grounds drawer.
Remove the grounds drawer and empty the grounds in
an appropriate container.
Note: The grounds drawer must be emptied only when
the machine requires it and when the machine is turned
on.
Emptying the drawer with the machine turned off does
not allow the machine to register that it has been
emptied.
To be able to make the machine functional, the side door
must be closed.
The tank must be removed and refilled with fresh
drinking water.
Open the side door and empty the drip tray under the
brew group)
Insert the milk container in the appropriate compartment
Press on the display in order to proceed with manually
priming the water circuit. The machine performs an
automatic attempt to prime the circuit. If this attempt
does not perform correctly you must proceed with these
instructions.
Contact the customer service center (toll free number) to
request assistance on how to resolve the problem.
Repeat the operation as described in the appropriate
section.
see page 13 and 27.
see page 13 and 28.