Error Codes - Saeco GranAroma SM6585 Mode D'emploi

2 Fill the water tank with fresh water up to the CALC CLEAN level indication and switch the machine
back on. The machine will heat up and perform an automatic rinsing cycle.
3 Before brewing any drinks, perform a manual rinsing cycle. To perform a manual rinsing cycle, first
dispense half a water tank of hot water and then brew 2 cups of pre-ground coffee without adding
ground coffee.
Note: If the descaling procedure was not completed, the machine will require another descaling
procedure as soon as possible.

Error codes

Below you find a list of the error codes showing problems that you can solve yourself. Video
instructions are available on www.saeco.com/care. If another error code appears, please contact the
Philips Consumer Care Center in your country. For contact details, see the warranty leaflet.
Error Problem
code
01 The coffee funnel is
clogged.
03 The brew group is dirty
or not well-greased.
04 The brew group is not
positioned correctly.
05 There is air in the water
circuit.
The AquaClean filter
was not prepared
properly before
installation or it is
clogged.
11 The machine needs to
adjust to room
temperature
14 The machine is
overheated.
Possible solution
Switch off the machine and unplug it. Remove the brew group.
Then open the lid of the pre-ground coffee compartment and
insert the spoon handle. Move the handle up and down until
the clogged ground coffee falls down (Fig. 37). Visit
www.saeco.com/care for detailed video instructions.
Switch off the machine. Rinse the brew group with fresh water,
let it air-dry and then lubricate it (see 'Lubricating the brew
group'). Consult chapter 'Cleaning the brew group' or visit
www.saeco.com/care for detailed video instructions. Then
switch the machine on again.
Switch off the machine. Remove the brew group and reinsert it.
Make sure that the brew group is in the correct position before
you insert it. Consult chapter 'Handling the brew group' or visit
www.saeco.com/care for detailed video instructions. Then
switch the machine on again.
Restart the machine by switching it off and on again. If this
works, dispense 2-3 cups of hot water. Descale the machine if
you have not done so for a longer period of time.
Remove the AquaClean filter and try to brew a coffee again. If
this works, make sure that the AquaClean filter is prepared
properly before you place it back. Put the AquaClean filter
back into the water tank. If this still does not work, the filter
might be clogged and needs to be replaced.
Allow some time for the machine to adjust from
transport/outdoor temperature to room temperature. Switch
off the machine for 30 minutes and switch it on again. If this
does not work, contact the Consumer Care Center in your
country. For contact details, see the warranty leaflet.
Switch off the machine and switch it back on after 30 minutes.
English
17