Error Codes - Saeco PRIMEA Touch Plus Mode D'emploi

46

error Codes

gUIDE mESSAgE THAT APPEARS
restart the machine
call assistance
insert drip tray
close coffee bean container
add ground coffee
insert brew group
insert dreg drawer
empty dreg drawer
close side door
refill water tank
empty drip tray
insert the milk container
prime the machine
circuit priming failure
the descaling cycle has not been completed
correctly
milk rinsing
milk cleaning
prime the circuit
All manuals and user guides at all-guides.com
HOW TO REmOVE THE mESSAgE
turn off and after 30 minutes turn the machine on again
to restore normal operation.
contact an authorized service center.
insert drip tray under the brew group.
Close the coffee bean hopper cover to be able to brew
any beverage.
Add one scoop of pre-ground coffee to the pre-ground
bypass doser.
Insert the brew group in its place.
insert the dregdrawer.
remove the dregdrawer and empty the grounds in an
appropriate container.
note: the dregdrawer must be emptied only when the
machine signals to do so, and when the machine is
turned on.
Emptying the drawer with the machine turned off does
not allow the machine to register that it has been
emptied.
close the side door of the machine.
Refill the water tank with fresh drinking water.
open the side door and empty the drip tray under the
brew group.
insert the milk container in its compartment.
Press on the display in order to proceed with manually
priming the water circuit. The machine performs an
automatic attempt to prime the circuit. if this attempt
does not perform correctly you must proceed with these
instructions.
contact an authorized service center.
Repeat the operation as described in the descaling
section.
See page 13 and 28.
See page 13 and 29.
Set the SBS dial to the position shown on the display
screen, and proceed with cleaning the brew group. Then,
prime the circuit once again.