6
INSTALLATION
MANUAL PRIMING OF THE WATER CIRCUIT
Manually prime the water circuit only when the following
display appears.
Note: fi rst make sure that the water tank is full.
1
Position a container under the hot
water spout (it is possible that
water will not come out of the
spout).
SETTING THE LANGUAGE AND THE CLOCK
When the machine is switched-on for the fi rst time, it requires the selection of the desired language.
This allows you to adjust the parameters of the beverages to the typical parameters of the country
where the machine is used. This is why some languages are differentiated also by country.
1
deutsch
language
français
1/2
italiano (ch)
Select the desired language.
Press
for the other languages.
4
self-test
demo
The machine starts and displays
the menu in the selected
language.
2
priming the machine
Press the display once and the
machine will begin priming the
water circuit.
2
Italiano (i)
deutsch
english
français
nederlands
italiano (ch)
ok
Press to select the desired
language.
4
demo
If desired, the "demo" function (see page 26)
may be activated by pressing the key, each time
the machine carries out a self-diagnosis.
priming the machine
start
Italiano (i)
language
english
1/2
nederlands
ok
self-test
avvio
3
When the prime circuit cycle is
fi nished, remove the container.
The machine is now ready for
use.
3
deutsch
language
français
1/2
italiano (ch)
Press "ok".
5
See manual on page 34 to
adjust the clock.
Italiano (i)
english
nederlands
ok