Error Codes - Saeco Primea Touch Plus Mode D'emploi

GUIDE MESSAGE THAT APPEARS
(switch the machine off and then on again to
solve the problem)
(call customer service center.)
(insert drip tray)
(close coffee container)
(add ground coffee)
(insert the brew unit)
(insert dreg drawer)
(empty dreg drawer)
(close the door)
(refi ll water tank)
(empty drip tray)
(insert the milk container)
(prime the circuit)
(circuit priming failure)
(the descaling cycle has not been completed
correctly)
(rinse milk)
(milk cleaning)

ERROR CODES

HOW TO REMOVE THE MESSAGE
Turn off and after 30 minutes turn the machine on again
to restore normal operation.
Problem that requires the intervention of the customer
service center.
Insert drip tray under the brew group.
Close the coffee bean hopper cover to be able to brew
any product.
This message guides the user when, in the customized
product programming, the use of this type of coffee has
been chosen.
Insert the brew group in its place.
Insert the dregsdrawer
Remove the dregsdrawer and empty the grounds in an
appropriate container.
Note: The dregsdrawer must be emptied only when the
machine requires it and when the machine is turned on.
Emptying the drawer with the machine turned off does
not allow the machine to register that it has been
emptied.
To be able to make the machine functional, the side door
must be closed.
The tank must be removed and refi lled with fresh
drinking water.
Open the side door and empty the drip tray under the
brew group)
Insert the milk container in the appropriate compartment
Press on the display in order to proceed with manually
priming the water circuit. The machine performs an
automatic attempt to prime the circuit. If this attempt
does not perform correctly you must proceed with these
instructions.
Contact the customer service center (toll free number) to
request assistance on how to resolve the problem.
Repeat the operation as described in the appropriate
section.
see page 13 and 27.
see page 13 and 28.
41