GYS GYSFLASH 18.12 PL-E Manuel D'utilisation page 8

Translation of the original instructions
• During the charge, the battery must be placed in a well
• The terminal of the battery that is not connected to the car
• After the starting/charging process, disconnect the booster/
Connection:
• This device must be connected to an earthed power supply
• Connection to the mains must be made according to the national
Maintenance:
• If the power supply cable is damaged, it must be replaced
• Service should be performed by a qualified person
• Warning! Always remove the power plug from the wall socket
• Under no circumstances should solvents or other aggressive
• Clean the device's surfaces with a soft, dry cloth.
Regulations:
• The device complies with European Directive.
• The certificate of compliance is available on our website.
• EAC conformity mark (Eurasian Economic Commission)
• Equipment in compliance with British requirements. The British
• Equipment in conformity with Moroccan standards.
• The declaration C‫( م‬CMIM) of conformity is available on our
Disposal:
• This product should be disposed of at an appropriate recycling
8
GYSFLASH 18.12 PL-E
ventilated area.
frame must be connected first. The other connection must be
made on the car frame, far from the battery and the fuel line.
The battery charger must be connected to the power supply
network.
battery charger from the power supply network and remove
the connector from the car frame and then the connector from
the battery, in this order.
installation regulations.
by the manufacturer, its service agent or an equally qualified
person.
before carrying out any work on the device.
cleaning agents be used.
Declaration of Conformity is available on our website (see home
page).
website (see cover page).
facility. Do not dispose of in domestic waste.
EN