INSTALLATION
Measure the distance between the cooking surface
and the bottom of the range hood. A distance of 27"
to 30" is recommended*.
*
Due to different ceiling height configurations, the
recommended height may not be applicable
Step 1: You have two options for installing this range hood (see INSTALLATION DIAGRAMS on page 24):
A. Determine the venting method and proceed if you would like to vent VERTICALLY.
Using references in the Height & Clearance diagram, determine and clearly mark the centerline
1.
on the bottom of the cabinet.
2.
Draw electrical wires through cabinet access opening on top of the range hood (refer to figure
3), center the hood beneath the cabinet and flush with the front of the cabinet.
3.
From inside the hood, place hood mounting screws in the exact center of each knockout holes
and secure to the cabinet bottom. Tighten all screws until secure. Be careful when using
electrical screwdriver in order not to damage the range hood. Connect and secure the 8'' round
metal duct (refer to figure 4). Skip Part B below and proceed to Step 2.
Figure
B. Determine the venting method and proceed if you would like to vent HORIZONTALLY.
Using references in the Height & Clearance diagram, determine and clearly mark a centerline
1.
on the wall. Place two mounting screws on the wall, leaving a gap of 1/8'' from the wall. To
secure the hood onto the studs in the wall is highly recommended.
2.
Secure the mounting bracket to the back of the hood with the six screws, as shown in figure 5.
3.
Puncture the knockout wire access hole and rear duct access hole on the back of the hood, draw
electrical wires through the wire access hole (refer to figure 6) and attach rectangular vent
adapter.
4.
Align the mounting bracket to the screws on the wall and hang the hood in place as illustrated
in figure 7.
All manuals and user guides at all-guides.com
.
CAUTION: Make certain the range hood is secure before releasing!
3
6
5
Figure
Figure
4
Figure
Figure
26
7