Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
IMPORTANT
• A minimum of 8" round (standard for this range hood) must be used to maintain maximum airflow
efficiency.
• Always use rigid type metal/aluminum ducts if available to maximize airflow when connecting to duct
provided.
VENTING METHODS
INSTALLATION DIAGRAMS
Vent work can terminate either through the roof or wall. To vent through a wall, a 90° elbow may be
•
needed
.
This range hood is factory set for vertical venting using round or rectangular vent adapter but can be
•
converted to horizontal venting by swapping the round vent adapter on top with rectangular vent adapter
behind the range hood as shown below
Horizontal venting
ELECTRICAL REQUIREMENTS AND INSTALLATION
WARNING
THIS RANGE HOOD MUST BE PROPERLY GROUNDED. TURN OFF ELECTRICAL POWER AT SERVICE ENTRANCE BEFORE
WIRING. CHECK TO MAKE SURE THAT THE ELECTRIC CHORD IS NOT IN CONTACT WITH THE SHARP EDGES OF THE
APPLIANCE.
IMPROPER GROUNDING CAN RESULT IN A RISK OF ELECTRIC SHOCK. CONSULT A QUALIFIED ELECTRICIAN IF THE
GROUNDING INSTRUCTIONS ARE NOT COMPLETELY UNDERSTOOD OR IF THERE IS DOUBT AS TO WHETHER THE
APPLIANCE IS PROPERLY GROUNDED. DO NOT USE AN EXTENSION CORD. IF THE POWER SUPPLY CORD IS TOO
SHORT, HAVE A QUALIFIED ELECTRICIAN INSTALL AN OUTLET NEAR THE APPLIANCE.
• This appliance must be plugged into an outlet that is properly installed and grounded. In the event of an
electrical short circuit, grounding reduces the risk of electric shock by providing an escape wire for the
electric current.
• Position the outlet offset so that the power cord will not interfere with the round duct. Make sure this
does not interfere with the mounting bracket.
All manuals and user guides at all-guides.com
:
Option 1:
Wall cap
24
Option 2:
Vertical venting
Roof cap
Publicité
Table des Matières
