Compatible Accessories; Acoustic Warning Signal - Festool TID 18 Notice D'utilisation D'origine

9.1

Compatible accessories

This power tool is compatible with commercial­
ly available tools with 1/4" hex shank, as per
DIN 3126 type E 6.3. [5]
CENTROTEC accessories are not com­
patible with this power tool.
9.2 Changing tools [3]
► Pull the sleeve of the bit locking system for­
ward to release the insertion tool.
► Remove insertion tool.
► Push the new insertion tool into the locking
sleeve until it audibly clicks into place.
9.3 Changing the bit in the insertion tool [3]
► Remove the bit from the insertion tool.
► Insert a new bit into the insertion tool.
10 Working with the machine
WARNING
Risk of injury
► Only attach the power tool to the screw
when it is switched off.
► Always secure the workpiece in such a
manner that it cannot move.
► Keep hands away from the rotating inser­
tion tools.
CAUTION
Risk of burns
Tool holder and tools can become very hot
during operation!
► Wear protective gloves when changing the
tools!
► Allow to cool before attaching to belt clip.
10.1 Bit store [1-9]
WARNING
Risk of injury from metal cuttings in the bit
store.
► Clean the bit store regularly and clear out
metal cuttings.
Magnetic, to pick up bits.

10.2 Acoustic warning signal

Acoustic warning signals sound and the tool
switches off in the following operating states:
Battery empty/incompatible
or tool overloaded.
–
–
When pressing the on/off
switch. Tool has overheated.
–
Tool is faulty.
–
11 Service and maintenance
WARNING
Risk of injury, electric shock
► Always remove the battery pack from the
power tool before performing any mainte­
nance or service work.
► All maintenance and repair work that re­
quires the power tool to be opened up
should always be carried out by an author­
ised service workshop.
Customer service and repairs must
only be carried out by the manufac­
turer or service workshops. Find the
nearest address at:
www.festool.co.uk/service
Always use original Festool spare
EKAT
4
parts. Order no. at:
www.festool.co.uk/service
5
3
2
1
To ensure constant air circulation, always keep
the cooling air openings in the motor housing
clean and free of blockages.
Keep the contacts on the power tool, charger
and battery pack clean.
12 Environment
Do not dispose of the device in the
household waste! Recycle devices, ac­
cessories and packaging. Observe appli­
cable national regulations.
EU only: In accordance with the European Di­
rective on waste electrical and electronic
equipment and implementation in national law,
used power tools must be collected separately
and handed in for environmentally friendly re­
cycling.
Charge/change the bat­
tery.
Reduce the load on the
tool.
Once it has cooled down,
restart the tool.
Contact the manufacturer
to rectify the fault.
English
15