Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Work breaks and finishing work
Always attach the protective cover to the device
after finishing work [Fig. 3].
7
Service and maintenance
Customer service and repair only
through manufacturer or service
workshops: Please find the nearest
address at: www.festool.com/service
Only use original Festool spare parts!
EKAT
4
Order No. at: www.festool.com/service
5
3
2
1
Information on REACh: www.festool.com/reach
7.1
Replacing the blade rollers
CAUTION
Sharp, pointed edges!
Risk of injury!
Handle the device with extra care and always
wear suitable protective gloves.
[Fig. 5]
Loosen the flat head screws by turning the aux-
iliary plates at either end of the roller in oppo-
site directions.
Remove the first roller.
Remove the second roller from the device to-
gether with the shaft and then pull the roller
from the shaft.
Slide a new roller onto the shaft.
Note: The points on the roller should
always point towards the centre of
the device.
Insert the roller with shaft into the device and
attach the second roller (Note direction!).
Tighten the two screws.
Replace the second pair of rollers in the same
way.
The play of the blade rollers ensures that the
device will function correctly over slightly un-
even surfaces.
8
Accessories
The order numbers of the accessories and tools can
be found in the Festool catalogue or on the Internet
under "www.festool.com".
TP 220
GB
9
Publicité
Table des Matières
