General Power Tool Safety Warnings; Emission Levels - Festool TID 18 Notice D'utilisation D'origine

English
1 Symbols
Warning of general danger
Warning of electric shock
Read the operating manual and safety
instructions.
Wear ear protection.
Wear protective goggles.
Inserting the battery pack
Removing the battery pack
CE marking: Confirms the conformity
of the power tool with the European
Community directives.
Do not dispose of it with domestic
waste.
Tip or advice
Handling instruction
2 Safety warnings
2.1

General power tool safety warnings

WARNING! Read all safety warnings, in­
structions, illustrations and specifica­
tions provided with this power tool. Failure to
follow all instructions listed below may result in
electric shock, fire and/or serious injury.
Save all warnings and instructions for future
reference.
The term "power tool" in the warnings refers to
your mains-operated (corded) power tool or
battery-operated (cordless) power tool.
Follow the operating manual for the charger
and the battery pack.
2.2 Tool-specific safety instructions for
cordless impact screwdriver
– Hold the power tool by insulated gripping
surfaces, when performing an operation
where the cutting accessory may contact
hidden wiring. Autting accessory contact­
ing a "live" wire may make exposed metal
12
parts of the power tool "live" and could give
the operator an electric shock.
– Use appropriate detection devices to look
for any hidden supply lines or consult your
local utility company. If the insertion tool
makes contact with live cables, it can result
in fire and electric shock. Damage to a gas
pipe can lead to an explosion. Penetration
of a water pipe can result in damage to
property.
–
Wear suitable personal protective equip­
ment: Ear protection and safety goggles.
– Hold the power tool firmly in your hand.
Make sure the speed is adjusted correctly
when screwdriving. Be prepared for high
reaction torque, which can arise when
working with the power tool.
– Do not use the power tool in the rain or in
damp surroundings. Moisture in the power
tool may cause a short circuit and burning.
Wait until the power tool has come to a
–
complete halt before placing it down. The
insertion tool can get caught and lead to a
loss of control of the power tool.
Avoid unintentional activation. Carrying
–
the electric power tool with your fingers on
the on/off switch can lead to accidents.
If you are not using the power tool, set the
rotational direction switch/safety lock [1-8]
to the centre position to lock the on/off
switch.
Do not use power supply units or third-
–
party battery packs to operate cordless
power tools. Do not use third-party charg­
ers to charge the battery packs. The use of
accessories not expressly authorised by the
manufacturer can result in electric shocks
and/or serious accidents.
Only use tools and accessories approved
–
by Festool for this power tool. The use of
non-approved tools or accessories may in­
crease the risk of injury and cause serious­
ly unbalance the machine. This can worsen
the quality of the working results and in­
crease the wear of the machine.
2.3

Emission levels

The levels determined in accordance with
EN 62841 are typically: