Control Unit And Foot Control - NSK Surgic Pro Serie Manuel D'utilisation

3. Control Unit and Foot Control

(1) Light Key
(2) Coolant Key
(3) FWD/REV Key
(4) GEAR Key
(5) MEMORY Key
(6) CAL Key
3-1 Keys on the Control Unit
(1) Light Key
Select the light level. (OFF -> LOW->HIGH) Repeat press Key to cycle through light levels. (Default:HIGH)
(2) Coolant Key
Use to select 6 levels of coolant solution flow from 0 to 5, repeat press Key to cycle through coolant flow levels.
(3) FWD/REV Key
Use to select the direction of rotation. Press this Key once to change the rotational direction. (Once in Reverse the
Control Unit audibly warns with a 'beep')
(4) GEAR Key
Use to set gear ratio of the attached handpiece before use. Repeat press this Key until the LCD display indicates the
correct gear ratio of the handpiece.
(5) MEMORY Key
Use to memorize the program parameters (see 6-1 Programming the System Operation) set by the operator. Press and
hold this Key for approx. 1 second to memorize parameters. When beep sounds, the new program parameters have
been memorized.
(6) CAL Key
Use to activate calibration procedure of the handpiece before use.
(7) SPEED Key (- +)
Use to set the Micromotor speed. Press [+] Key to increase, and [-] Key to decrease speed. When keep pushing the
key to change the speed quickly. (When the upper and lower speed limits are reached an audible alarm 'beep' is
sounded).
(8) TORQUE Key (- +)
Use to set the torque range. Press [+] Key to increase and [-] Key to decrease torque range. When keep pushing the
key to change the torque range quickly. (When the upper and lower torque range limits are reached an audible alarm
'beep' is sounded). The torque range setting should be selected according to the attached handpiece gear ratio.
(9) PROGRAM Key (- +)
Select the available programs. (1 to 8) Press [+] Key to ascend and [-] Key to descend program number. You will find
all program numbers sequentially by pressing Keys.
USB REC (Surgic Pro + ONLY)
(10)
Press this Key to record the Surgic Pro series operation to USB flash drive.
A short push will save data being memorized to USB flash drive. A long push (about 2 seconds) will erase data saved
on the control unit memory.
Calibration Load
Irrigation Pump
(7) SPEED Key
(8) TORQUE Key
(9) PROGRAM Key
Motor Cord
(10) USB REC
Connector Socket
Coolant Solution
Hanger Post Holder
Main Power Switch
AC Power Cord
Connector socket
Fuse Holder
*
The item which does not have number is explained in context.
5
USB flash drive Socket
Foot Control Cord
Connector Socket