Fuse Replacement - NSK Surgic Pro Serie Manuel D'utilisation

Errors Related to the USB Function (Displayed on the "Memory Time" indicator)
Error code
USB flash drive other than the type stipulated is connected
UE0
("EO" will be displayed on the SPEED screen).
UE1 USB flash drive module circuit error.
Data cannot been stored on USB flash drive for the one of
the following reasons:
• Lack of available memory on USB flash drive.
UE2
• Use of a USB flash drive on which copying is prohibited.
• File name is already in use.
• Other USB flash drive related error.
Error
Screen is blank.
The maximum rotation speed and
"---" are alternately displayed on the
speed display.
Will not rotate even if the Foot Control
is pressed.

9. Fuse Replacement

If the Control Unit does not function, check the fuses (Fuse Box lock
located on the rear of the Control Unit). To access the Fuse, use
a pointed tool push on the fuse locking latch and the drawer will
spring open. (Fig.19)
Cause of Error
Cause of Error
Plug to power source is not properly
inserted.
Blown fuse.
Malfunction of power switch.
Power is on while Foot Control is being
pressed.
Foot Control malfunction.
Control Unit malfunction.
Cord connection is loose.
Malfunction of Control Unit or Foot
Control.
Fuse Ratings
120V T3.15AL 250V
230V T1.6AL 250V
18
Remedy
Please connect using the proper type of
USB flash drive.
Notify dealer where device was purchased.
• Replace USB flash drive.
• Remove lock that prevents copying.
• Change the file name.
• Read instructions for USB flash drive use.
Remedy
Check to make plug is in.
Replace fuse.
Request repair.
Remove foot from Foot Control.
If the problem is solved by removing
the Foot Control, the Foot Control has
malfunctioned. Repair is required.
If the problem is not solved by
removing the Foot Control, the unit
has malfunctioned. Repair is required.
Check connection.
If the problem is not solved by
checking the connection, system
repair is required.
Fuse
Fig.19