Internal Memory; Protection Circuit; Error Code & Troubleshooting - NSK Surgic Pro Serie Manuel D'utilisation

• Total recording time is about 100 minutes.
• Do not insert a USB flash drive during operation. Only insert after operations are completed in order to
CAUTION
store data.
• Do not use data stored in USB flash drive for diagnostic purposes.
• Do not use a USB flash drive other than USB 2.0. (To 32GB verification being completed)
• Do not remove USB flash drive while the LED lamp is on or blinking.
• The LED lamp and their meanings are given below:
lamp on = internal memory is copying data, blinking = USB flash drive is storing data.
• This device is not guaranteed to work with all USB flash drive. It may not work with USB flash drive
with security functions or those which use a great deal of electricity.
• Do not turn the device on or off with the USB flash drive inserted.
• Be careful to insert the USB flash drive in the correct direction.
• When a USB flash drive is not connected, close the cover of the connector.
• If power is turned off, the internal memory will be erased. Turn off power after storing data on USB
flash drive.

6-5-1 Internal memory

After power is turned on and the motor begins to rotate, memorizing will begin automatically (A USB flash drive
need not be connected).
6-5-2 Transmitting stored data
1) Insert a USB flash drive (When correctly recognized, the USB flash drive mark will appear on the LCD).
2) Push the USB REC key to copy stored data onto the USB flash drive (During the control unit copying the data.
LED lamp blink).
NOTICE
• Distinguish rotating direction and torque that has been set using line types.
• While in operation (memorizing), the LED lamp will light up. About 10 seconds after operation stops,
the LED lamp will turn off and memorizing will stop temporarily (The time counter will also stop
temporarily).
6-5-3 Resetting
Press the USB REC key for at least 2 seconds. The amount of remaining recording time will be reset after the
beep goes off (Initialized time: 100 min).

7. Protection Circuit

A protection circuit automatically functions to protect the motor and the Control Unit if the motor is ever overloaded.
Power supply to the motor will automatically be terminated an Error code will be displayed on the Control Unit.
When torque exceeds the set figures, "SAFE" will appear on the LCD, and the device will stop.
*Resetting the Protection Circuit
To reset the Protection Circuit, release and then depress the Speed Control Pedal.
8. Error Code & Troubleshooting
If an operational problem occurs the display will show an Error Code allowing immediate problem diagnosis.
When an error occurs, there will be a beep and an Error Code will appear on the LCD. The Error Code will blink until
the error is alleviated. The USB REC LCD will go on for about 10 seconds.
Release and then depress the Foot Control to perform an error check again. If no problem is found, the error is
canceled and operations can continue.
16