Care And Maintenance; Assembly Notes - Energetics Deluxe Multi Gym 10.1 Mode D'emploi

Care and Maintenance

The home exerciser should not be used or stored in a moist area because of possible corrosion.
-
Check at least every 4 weeks that all connecting elements are tightly fitted and in good condition.
-
In case of repair please ask your dealer for advice.
-
Replace defective components immediately and/or keep the equipment out of use until repair.
-
Only use original spare parts for repair.
-
Use a damp cloth to clean the Home Exerciser and avoid the use of aggressive detergents when
-
cleaning the Home Exerciser.
After exercising, immediately wipe of the sweat; perspiration can ruin the appearance and proper
-
function of the Home Exerciser.

Assembly notes

The following tools are required for assembly: Two adjustable wrenches and Allen Wrenches.
-
Always only use Carriage Bolt to insert through the SQUARE hole on component that needs to be
-
assembled. Attach washer only to end of the Carriage Bolt.
Always only use Allen Bolts or Hex Bolts insert through the ROUND hole on component that need to
-
be assembled.
Always wait until all bolts are installed to the component and then fasten the bolts. Do not fasten each
-
bolt right after it is installed.
ASSEMBLED DIMENSION: L 237 x W 115 x H 204 cm
-
Symbols shown in Assembled Instruction:
Cable Tension Adjustment
Adjust the tension of the Cable System by moving the position of lower Pulley on the Double
Floating Pulley Brackets.
If the tension is too loose, move the lower pulley up by one hole.
If the tension is too tight, move the lower pulley down by one hole.
Lower Pulley
Fasten Nuts and Bolts.
After all components and hardware have been assembled in current and
previous steps. Securely tighten all Nuts and Bolts.
NOTE: Do not over tighten any component with pivotal function. Make
sure all pivotal components are able to move freely.
Do not tighten all Nuts and Bolts in this step yet.
When Fasten Nuts and Bolts symbol appeared in next step, then make sure to
fasten all Bolts that have been installed.
5