Table Des Matières; Owner's Information - Xylem CentriPro Aquavar ABII+ 3AB2 Manuel D'instruction

Owner's Information

Owner's Information
Controller Model Number:
Controller Serial Number:
Pump Model Number:
Pump Serial Number:
Motor Model Number:
Motor SFA:
Tank Serial Number:
Installer:
Installer Telephone Number:
Installation Date:
Wire Lengths (Feet)
Service Entrance to Controller:
Controller to Motor:
Incoming Voltage:
NOTICE: RECORD THE MODEL NUMBERS
AND SERIAL NUMBERS FROM THE
PUMP AND CONTROLLER IN THIS
INSTRUCTION MANUAL FOR FUTURE
REFERENCE. GIVE IT TO THE OWNER
OR AFFIX IT TO THE CONTROLLER
WHEN FINISHED WITH THE
INSTALLATION.
Tested to UL 508C and CSA 22.2,
No. 274-13 Standards By Canadian
®
Standards Association
C US
File #LR38549
PLEASE USE THIS CONTROLLER INSTALLATION, OPERATION AND TROUBLESHOOTING
MANUAL (IOM) IN CONJUNCTION WITH THE PUMP IOM. THE CONTROLLER IOM COVERS THE
CONTROLLER ELECTRICAL INSTALLATION AND ANY SPECIAL INSTALLATION PROCEDURES
REQUIRED WITH VARIABLE SPEED CONTROLLERS.
XYLEM WILL NOT BE RESPONSIBLE FOR ANY DAMAGES TO ANY INSTALLATION WHERE THE
PRESSURE RELIEF VALVE IS ALLOWED TO DISCHARGE INTO A FINISHED LIVING SPACE OR TO
OTHERWISE DAMAGE A CUSTOMERS PROPERTY. PLUMBING SAFETY DEVICES SUCH AS PRESSURE
RELIEF VALVES TO AN APPROPRIATE DRAIN IS THE RESPONSIBILITY OF THE INSTALLER AND IS
OUT OF OUR CONTROL.
2
Table of Contents
Table of Contents
SUBJECT
1. Safety Instructions ..................................................... 3
Ratings ...................................................................... 3
Required Materials .................................................... 3
2. Typical Installation .................................................... 3
Controller ............................................................... 3-4
Pump and Piping ........................................................ 4
Tank Sizing and Tank Pressure Setting ........................ 4
Wiring - Transducer, Motor, etc. ............................ 4-6
User Interface Board .................................................. 6
3. Installer Pre-Start Selections ...................................... 7
Controller Status Indicator ........................................ 7
Status and Parameter Display ..................................... 7
Setpoint and Parameter Adjust Buttons ...................... 7
Display Mode Button ................................................. 7
Setpoint Select Input .................................................. 8
Minimum Frequency (Speed) Switch .......................... 8
Dry Run Restart ......................................................... 8
Low Pressure Cut-Off ................................................ 8
Pressure Drop ............................................................ 8
Setting the Ramp Setting ............................................ 8
Motor Overload Setting Dial ..................................... 8
4. Start-Up Procedure .................................................... 9
Purging System, Adjusting Pressure ............................ 9
Pressure Adjustment Pushbuttons ............................... 9
Check for Leaks, Checking Rotation .......................... 9
5. Run/Stop Input Options ............................................ 9
Transducer Jumper ................................................... 10
6. Advanced Menu ................................................. 10-12
7. Troubleshooting, Fault Codes ............................. 13-17
8. Insulation and Winding Resistance Tests .................. 18
Limited Warranty ........................................................ 20
PAGE