Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Operating Instructions
Functional test
The output signal must be proportional to the pressure. If not, this might point to a damage of
the diaphragm. In that case refer to chapter 9 „Troubleshooting".
Open pressure connections only after the system is without pressure!
„
Observe the ambient and working conditions outlined in section 8 „Technical
„
data.
Warning
Please make sure that the pressure transmitter is only used within the overload
„
threshold limit at all times!
When touching the pressure transmitter, keep in mind that the surfaces of the
instrument components might get hot during operation.
Caution
9. Maintenance
SICK pressure transmitters require no maintenance.
„
Have repairs performed by the manufacturer only.
„
10. Trouble shooting
Open pressure connections only after the system is without pressure!
Take precautions with regard to remaining media in removed pressure transmit-
„
ters. Remaining media in the pressure port may be hazardous or toxic!
Warning
Remove the pressure transmitter from service and mark it to prevent it from
„
Warning
being used again accidentally, if it becomes damaged or unsafe for operation.
Have repairs performed by the manufacturer only.
„
Warning
Do not insert any pointed or hard objects into the pressure port for cleaning to prevent
damage to the diaphragm of the pressure connection.
28
8. Specifications / 9. Maintenance / 10. Trouble shooting
© SICK AG • Germany • All rights reserved
PBT
GB
8013153/1B2T/2021-03-17
Publicité
Table des Matières
