Pd 5201, Pd 5206; Standard Functions - Heidolph PD 5001 Mode D'emploi

IEI
9. PD 5201, PD 5206 (figs. 48, 49)
PD 5201 and PD 5206 pump drives are splash-proof (IP 55).
-
Service work is limited to expert personnel authorized to do so by Heidolph.
Interface sockets (37 & 39) need to be closed with an interface plug or blind plug all
the time, not to void splash protection.

9.1. Standard functions

Turn item ON with power switch (29) located on
-
the item's rear panel.
Item runs through a processor self-test routine.
-
The following parameters are displayed, one after
the other:
all display (41) bars and all Select LEDs are ON.
-
pump head selected is displayed (e.g. „Pu 1).
-
gearbox transmission ratio is displayed, e.g.
-
„5.066
hose ID selected is displayed, e.g. „3,1"
-
possible backstroke is displayed. e.g. „r on".
-
Item is ready to go at this point.
-
Use sense of rotation key (31) to select sense of
-
44
34
32
40
31
40 35
33
60
31:
41
32:
33:
36
34:
35:
36:
Bild 49
fig. 48
29
39
37
Direction of rotation
Start/Stop
Maximum
conveyance
Calibration
Change value
Selection key