Mounting Of The Bikes On The Bike Carrier - PROUSER SILVERBIKE Notice D'assemblage Et De Sécurité

MOUNTING OF THE BIKES ON THE BIKE CARRIER

The first bike must be placed in the wheel holders closest to the car and fastened
to the upright frame using the frame holder.
Adjust the wheel holders by pushing them
in or pulling them out in such a way that
the bike wheels are inserted in these
holders as symmetrically as possible and as
far as possible. Attention: Do not pull out
the wheel holders beyond the red mark!
Use the straps to tightly secure the wheels
to the wheel holders.
Secure the bike frame to the upright frame
using the frame holder. Since the frame
holders do not have to be used in a fixed
point, you can try out several positions. It
is important to place the frame holders as
high as possible. Use the straps to secure
the bikes. With these straps, any bike can
be secured easily without placing a load on
the bike crank.
Place the second bike in opposite direction into the other wheel holders and
proceed as described above for the first bike.
Caution: When you put your bikes on the bike carrier, always keep in mind that
the tilting handle needs space upwards to unlock the tilting system!
Now secure the bikes using the long safety belt. Run the safety belt
through the bike frame and around the U frame and tighten firmly.
37