PROUSER SILVERBIKE Notice D'assemblage Et De Sécurité page 34

Step 3
Parts:
Assembly:
Slide the four short, blue straps through the little
slots in the wheel holder, starting inside-out, going
around the wheel holder and then outside-in (see
picture).
End result:
Unscrew the plastic rotary knob of each frame
holder, so the clamps can be folded open. First
attach the rubber ring around the U-frame and
put the clamp around it. Subsequently, re-attach
the holder and screw the plastic rotary knob until
you can just turn the frame holders (the frames of
the bikes have to be attached to it, so they have
to be movable). The sides with the straps are
intended to fasten the bike.
34