PROUSER SILVERBIKE Notice D'assemblage Et De Sécurité page 33

Step 2
Parts:
Assembly:
Slide the four wheel holders into the base frame. Make
sure to slide the wheel holders into the frame with the
ends pointing downwards (see picture). Fasten the
wheel holders using the plastic knobs. When adjusting
the wheel holders, they may not be pulled out beyond
the red mark!
Next, slide the upright frame (used to fasten the frame holders) into the square
hole of the base frame, the side with the eye welded to it pointing forward.
Tightly screw the plastic knob that is also supplied (including washer) into the
End result:
frame to fasten the upright frame. After that, tighten
the plastic knob on the side of the base frame so that
the upright frame is properly secured.
Plastic knob on the side
Eye including plastic knob
33
Marking