Mounting Of The Bikes On The Bike Carrier - PROUSER SAFFIER III Notice D'assemblage Et De Sécurité

MOUNTING OF THE BIKES ON THE BIKE CARRIER

Remove all parts from the bikes that could easily be lost (E-
bike batteries, bike pumps, speedometers, baskets, panniers,
bicycle seats etc.) during transport. These parts may become
loose by the increased air resistance and vibration and put
other road users at risk.
The first (and heaviest, max 20kg) bike has to be placed in the rear wheel holder
(the one which is the nearest to the car) and secured with the short frame holder
on the U-tube.
Adjust the wheel holders by pushing them
in or pulling them out in such a way that
the bike's wheels are inserted in these
holders as symmetrically as possible and
as far as possible. Attention: Do not pull
out the wheel holders beyond the red
mark! Use the straps to tightly secure the
wheels to the wheel holders.
Secure the bike frame to the U-frame
using the frame holder. Since the frame
holders do not have to be used in a fixed
point, you can try out several positions. It
is important to place the frame holders as
high as possible. Use the straps to secure
the bikes. With these straps, any bike can
be secured easily without placing a load
on the bike crank!
Place every next bike in opposite directions into the other wheel holders and
proceed as described above for the first bike.
Now secure the bikes using the long
safety belt. Run the safety belt through
the bike frame and around the U frame
and tighten firmly.
38