Initial Start-Up; Positioning The Charging Station; Installing The Boundary Wire - Grizzly MR 400 Notice D'utilisation Originale

GB
• If the power cable for this
equipment is damaged, it must
be replaced by the manufac-
turer, a customer service agent
of the same or a similarly quali-
fied person in order to prevent
hazards.
• Do not attempt to charge non-
rechargeable batteries in the
charger. The device could get
damaged.

Initial start-up

Regularly check the lawn area for
rocks, branches, wires and other
objects that may damage the de-
vice and the blades.
Positioning the charging
station
1. Select a flat position near a socket for
the charging station (12) with at least
2 m of space in front and 1 m behind.
2. Secure the charging station and the
charging station bumper (12b) with
the fixing nails (8).
The charging station bumper (12b)
is fastened to the side of the charg-
ing station outside the restricted lawn
area.
The working range indicator (12a) on
the charging station must be located
within the restricted lawn area.
3. Connect the charging station to the
charger (10) using the connectors
(9+13). Ensure that the connector
contacts marked with "1" and "2" are
engaged correctly.
78
Make sure that the charging sta-
tion (12) is positioned an adequate
distance away from ponds, pools
and steps.
We recommend installing a roof for
the charging station (12) to protect
it from weather damage.
Installing the boundary
wire
Before starting up the automatic lawn
mower, the boundary wire (6) must be
placed around the lawn area to be cov-
ered by the automatic lawn mower.
You can do this as follows:
- Mark out the lawn area with the hooks
(7).
- Bury the boundary wire (6) in the
ground (max. depth of 5 cm).
The automatic lawn mower
crosses over the boundary wire by
about 20 - 30 cm before it turns
around and searches for a new
path. Install the boundary wire ac-
cordingly to prevent damage.
For the initial installation, we rec-
ommend marking out the boundary
wire (6) with the hooks (7) in case
corrections need to be made at a
later date.
• The lawn area must be bordered as a
single enclosed area (see figure
• Any parallel boundary wires installed
at a distance of at least 10 cm are
identified as an obstacle by the au-
tomatic lawn mower and are evaded
(see figure k ).
j ).