Storch SL 1600 HD Mode D'emploi page 200

The display shows CODE
10
The status indicator on the
controller card repeatedly
flashes ten times
The display shows CODE
12
The status indicator on the
controller card repeatedly
flashes twelve times
The display shows CODE 15
The status indicator on the
controller card repeatedly
flashes 15 times
The display shows CODE
16.
The status indicator on the
controller card repeatedly
flashes 16 times
The display shows CODE 17
The status indicator on the
controller card repeatedly
flashes 17 times
Original instruction
Check the con- 1. Make sure that the motor intake is not blocked.
troller card for
2. Make sure that the motor fan is not damaged.
overheating.
3. Make sure that the controller card is correctly connected to the
backplane and that thermal compound has been applied to the
components.
4. Replace the controller.
5. Replace the motor.
Overcurrent pro- 1. Switch the power off and back on.
tection activated.
Check the cable 1. Switch the spray gun OFF and unplug the power cable from the
connections abo- device.
ve the motor.
2. Remove the motor cover.
3. Disconnect the motor cable connection and check the connector
for damage.
4. Reconnect the motor controller.
5. Switch on. If the error code is still shown, replace the motor.
Check the cable 1. Switch off the power (set to OFF).
connections. The
2. Disconnect the motor position sensor and check the connector
controller is not
for damage.
receiving a motor
position sensor
signal.
3. Reconnect sensor.
4. Switch on the power (set to ON). If the error code is still
shown, replace the motor.
Check the power 1. Switch the spray gun OFF and unplug the power cable from the
supply to the spraying device.
spraying device
2. Locate a power supply that is working properly to avoid damage
(the spraying
to the electronics.
device is con-
nected to a power
supply with an
incorrect voltage
rating).
200