Care Of Plated Parts; Door Glass Replacement - Napoleon WHD31P Manuel D'installation Et D'opération

maintenance
EN
10.3

care of plated parts

If the appliance is equipped with plated parts, you must clean fi ngerprints or other marks from the plated surfaces
before operating the appliance for the fi rst time. Use an ammonia-free or vinegar-based cleaner and a towel
to clean. If not cleaned properly before operating for the fi rst time, the marks can cause permanent blemishes
on the plating. After the plating is cured, the fi ngerprints and oils will not affect the fi nish and little maintenance
is required, just wipe clean as needed. Prolonged high temperature burning with the door ajar may cause
discolouration on plated parts.
note:
The protective wrap on plated parts is best removed when the assembly is at room temperature but this can
be improved if the assembly is warmed (i.e. using a hair dryer or similar heat source).
10.4

door glass replacement

WARNING
!
• Do not use substitute materials.
• Glass may be hot. Do not touch glass until cooled.
• Care must be taken when removing and disposing of any broken door glass or damaged components. Be
sure to vacuum up any broken glass from inside appliance before operation.
• Do not strike, slam, or scratch. Do not operate appliance with glass removed, cracked, broken, or scratched.
1. Place the door frame face down being careful not to scratch the paint.
2. Center the gasketed glass inside the door frame with the thick side of
the gasket facing up.
3. Bend the glass retainers, located along the edge of the door fram, over
the gasket holding the glass in place. Be careful not to break the glass.
38
W415-1337 / B / 09.25.18
6.1
GASKET
38.1
GLASS
GLASS
RETAINER
DOOR
FRAME