Horizontal Installation - Napoleon WHD31P Manuel D'installation Et D'opération

3.1

horizontal installation

Level and affix the mounting template to the wall at
A.
the desired location and height. The centre of the
vent pipe must be located between wall studs.
Using the template, mark the holes for the vent, gas
B.
and electrical outlets, and the mounting screws (see
"minimum clearances to combustibles section").
note:
There are 2 sets of 4 mounting screws. Choose
the appropriate set for either 16" (40.6cm) or 24"
(61cm) studs.
Remove the mounting template from the wall and
C.
cut the holes as marked.
Remove the 4 screws that secure the wall mounting
D.
plate to the appliance.
If flexible venting is to be used, remove the rigid
E.
firestop spacer.
The shield and deflector have been designed
F.
to accommodate a maximum wall depth of 12"
(30.5cm). Determine the depth of the wall and cut
the shield and deflector accordingly. The shield must
extend the full depth of the combustible wall.
Screw the shield together using the screws
G.
provided.
Secure the ring to the firestop plate on the back of
H.
the mounting plate using the 4 screws provided.
Bend the 6 tabs on the deflector as shown.
I.
Slide the shield onto the ring and align the
J.
holes. Using 6 of the screws provided,
secure the shield to the ring.
Attach the
K.
deflector above
the shield
assembly using
the 5 screws
provided.
Apply a bead of
L.
caulking (not supplied) to the flange. Insert
the shield assembly into the wall, level
the mounting plate, and secure it using 4
fasteners. The fasteners must be mounted to the wall studs.
venting installation
RIGID
FIRESTOP
SPACER
GAS
OUTLET
MOUNTING PLATE
CAULKING
FLANGE
DEFLECTOR
BACK OF WALL
MOUNTING PLATE
FINISH
MATERIAL
VENT
ELECTRICAL
OUTLET
BACK OF WALL
FIRESTOP
PLATE
RING
DETERMINE
THE
CORRECT
HEIGHT
W415-1337 / B / 09.25.18
EN
19