Care Of Plated Parts; Safety Barrier Removal; Fi Rebox Glass Door Removal - Napoleon Ascent Deep Serie Manuel Du Propriétaire

6.2

care of plated parts

If the appliance is equipped with plated parts, you must clean fi ngerprints or other marks from the plated surfaces
before operating the appliance for the fi rst time. Use an ammonia-free or vinegar-based cleaner and a towel
to clean. If not cleaned properly before operating for the fi rst time, the marks can cause permanent blemishes
on the plating. After the plating is cured, the fi ngerprints and oils will not affect the fi nish and little maintenance
is required, just wipe clean as needed. Prolonged high temperature burning with the door ajar may cause
discolouration on plated parts.
note:
The protective wrap on plated parts is best removed when the assembly is at room temperature but this can
be improved if the assembly is warmed (i.e. using a hair dryer or similar heat source).
6.3

safety barrier removal

WARNING
!
• Glass may be hot. Do not touch glass until cooled.
• If equipped with door latches that are part of a safety system, they must be properly engaged. Do not
operate the appliance with latches disengaged.
• Facing and/or fi nishing materials must not interfere with air fl ow through air openings, louvre openings,
operation of louvres, or doors/access for service. Observe all clearances when applying combustible
materials.
• Before door is removed, turn the appliance off and wait until appliance is cool to the touch. Doors are heavy
and fragile so handle with care.
A barrier designed to reduce the risk of burns from the
hot viewing glass is provided with the appliance and
must be installed.
Before the glass door can be removed, the safety screen
must be removed. Lift the safety screen off the slots, tilt the
top forward and remove from the appliance.
6.4 fi rebox glass door removal
Leave a hand on the glass door during entire door removal. The glass door is secured to the fi rebox with four
spring latches. Pull the handles of the latches forward (door latch tool supplied in manual baggie), then lift the
latches out from the door frame to release the door. Next, pivot the door forward until the top edge clears the front
of the appliance. Carefully grip the sides of the door lifting it off the appliance.
note:
These spring latches make up the spring relief system for
the appliance. Ensure the door opens freely and closes
sealed.
note:
When mounting the door, ensure there is equal space
on both the left and the right side. This allows for easy
installation of the front.
Reverse these steps to reinstall the door. Ensure safety screen
is installed correctly.
maintenance
B
A
17
W415-2913 / C / 09.21.20
EN