Maintenance; Daily Maintenance; Main Door Opening; Ash Disposal - Napoleon NPS45 Instructions D'installation Et D'opération

10.0

maintenance

10.1

daily maintenance

THE FRONT OF THE APPLIANCE BECOMES VERY HOT DURING OPERATION. LET THE APPLIANCE

10.1.1 main door opening

Open the side doors on either
A.
side of the appliance.
On the right side of the
B.
appliance are 2 latches, release
the latches by pulling the rear
handle forward and disengaging
the hook from the door frame.
Swing open the viewing door.
C.

10.1.2 ash disposal

Ashes should be placed in a metal container with a tight fi tting lid. The container should be placed on a non-
combustible fl oor, well away from combustible materials, pending fi nal disposal. If ashes are disposed of by burial
in soil or otherwise locally dispersed, they should be retained in the closed container until all cinders are thoroughly
cooled.

10.1.3 burn pot inspection

When burning, the fl ames should be bright orange with embers jumping from the
burn pot. If not see "pellet pile up maintenance" or "burn pot cleaning" sections.

10.1.4 care of plated parts

If the appliance is equipped with plated parts, you must clean fi ngerprints or other marks from the plated
surfaces before operating the appliance for the fi rst time. Use a glass cleaner or vinegar and towel to clean.
If not cleaned properly before operating for the fi rst time, the marks can cause permanent blemishes on the
plating. After the plating is cured, the fi ngerprints and oils will not affect the fi nish and little maintenance
is required, just wipe clean as needed. Prolonged high temperature burning with the door ajar may cause
discolouration on plated parts.
NOTE: The protective wrap on plated parts is best removed when the assembly is at room temperature
but this can be improved if the assembly is warmed, using a hair dryer or similar heat source.
WARNING
!
COOL COMPLETELY BEFORE CONDUCTING SERVICE.
Side
Door
40.2
40.3A
6.1
W415-1472 / B / 02.05.18
37
EN
Latch