SECTION 5
4. To install the new torch head assembly - Insert the new piece of heatshrink
tubing onto the pilot arc cable attached to the new torch head assembly.
Connect the pilot arc cable and the main power cable by reversing the
steps taken to disconnect them. Be sure to slide the heatshrink tubing
completely over the knife-splice connection. Apply heat to form the tubing
to the connection, ensuring that the connection is completely insulated.
(Several layers of electrical tape can also be used in place of heatshrink
tubing if desired).
New Heatshrink Tubing
5. Reattach main power cable using the 7/16" (11.1mm) and 5/8" (15.9mm)
wrenches. Tape pilot arc cable connection back to main power cable.
Electrical Tape
6. Slide the handle forward and thread it firmly onto the torch body.
146
MAINTENANCE
New Torch Head Assembly