EUROM THG12000 Livret D'instructions page 20

4-9 Place the burner with the operation panel and the flame screen on the
stand and secure with 4 M6 x 10mm bolts.
H = stay bolt I = headless screw J = washer K = gas inlet L = swivel nut
M = hose N = bolts
Step 3
3-2 Place the gas bottle container over the frame.
G = gas bottle container
Step 4
4-5 Screw the 3 supporting bolts for the reflector
screen into the middle of the 3 headless screws.
4-6 Screw the headless screws (with the washer in
between) with the other side held fast into the
upper cap of the flame screen.
4-7 Secure the rubber hose for the pressure regulator
to the underside of the burner and allow this to drop
into the stand.
Screw the gas hose nut tight to the burner's gas
4-8
inlet.
Step 5
5-4
5-5
5-6
- 20 -
Place the 3 segments that make up the reflector cap with the 9
bolts and wing nuts on the central plate and secure.
Screw the 3 washers over the pins on the flame screen and
place the reflector cap above the burner so that the pins fit
through the holes and the cap rests on the bolts.
Place 3 washers over the headless screws and secure this
whole construction above the cap with the 3 wing nuts.
P = wing nut Q = central plate R = segment
S = bolt