Unfasten Cooling Unit; Fig. 7 - Gas Valve; Fig. 8 - Burner And Burner Box; Fig. 9 - Igniter Electrode And Burner Box - Norcold 96 Serie Mode D'emploi

F
E

Fig. 7 - Gas Valve

1. Remove screw holding drip cup (Fig.6,A).
2. Remove screw holding burner cover (Fig.6,B). Remove cover.
3. Pull igniter wire (Fig.6,C) through grommet. Lay cover aside.
Warning!
Fire and explosion hazard. Always use two
!
wrenches to loosen and tighten the gas fi ttings to avoid dam-
aging fi ttings and creating a dangerous propane leak that could
lead to death or destruction of property. Do not overtighten!
4. At the gas valve (Fig.7,D), disconnect burner tube (Fig.7,E) run-
ning to burner; disconnect both wires at top of valve (Fig.7,F).
5. Remove burner screw (Fig.8,B). Remove burner (Fig.8,A). Lay
aside.
NOTE: There may be a washer(s) between the burner and the
burner box. If so, set aside.
6. Remove screw to igniter (Fig.9,C) electrode (behind burner con-
nection); carefully remove electrode from burner box. Lay aside.
7. Remove burner box mounting screw (Fig.8,C). Lay aside.
B
A

Fig. 8 - Burner and Burner Box

A. Burner
B. Burner screw
C. Electrode screw
www.norcold.com
To burner
D
C
C

Fig. 9 - Igniter Electrode and Burner Box

Unfasten Cooling Unit

2.7 2.7
A
B
C

Fig. 10 - Cooling Unit Mounting Screws

A. Condenser
B. Absorber screws
C. Absorber coils
Caution!
Condenser fi ns may be sharp. Use care or wear
!
cut resistant gloves
1. Remove screws (1x or 2x) holding condenser (Fig.10,A) to upper
rear of refrigerator. Lay aside.
2. Remove screws (Fig.10,B) (2x) holding absorber coils (Fig.10,C) to
the rear of refrigerator. Lay aside.
3. Cut aluminum HVAC tape that seals foam plate to back of refrig-
erator. Cut around entire perimeter of foam plate, at the indentation
in the tape.
4. Lift and remove cooling unit.
• Grasp the absorber coils on each side and pull up; let the drain
hose slip through opening in foamed plate.
5. Lay cooling unit aside; the unit must be packaged and returned to
Norcold.
Disassembly complete.
7