Connect Water Line; Restore Power Connections; Power On / Test - Norcold 96 Serie Mode D'emploi

Restore Power, cont'd.

Connect Water Line

5.2 5.2
Note:
Skip this step if the refrigerator is not equipped with
an ice maker.
1. Install the water valve and bracket assembly (2x) to the rear of the
refrigerator.
2. Connect the ice maker wire harness ground wire.
Warning!
Shock hazard. Be sure AC and DC electrical
!
power to the refrigerator are turned off.
3. Connect the ice maker wire harness wires (white and brown wires)
from the water solenoid valve.
4. Connect the incoming water line (Fig.1,G) at the refrigerator's
water valve.
5. Turn on water shut-off valve or RV water pump.
6. Check ports of water valve for leaks, repair leaks.
Warning!
Shock hazard. Do not continue until all water
!
leaks are repaired. Water leaks can result in electrical shock
and damage to the RV.

Restore Power Connections

5.3 5.3
When no propane or water leaks exist, restore electrical power to the
refrigerator as follows (Fig.1):
1. Connect RV's +12 VDC input wire to power board 12V terminal
12VDC.
2. Connect RV's 12 VDC ground wire to power board 12V terminal
GND.
3. Plug main AC power cord into power board and RV receptacle.
4. If ice maker equipped, plug the white AC power cord into RV
receptacle.
5. If cold weather heater equipped, install the cold weather heater
onto the cooling system.
6. If cold weather heater equipped, install cold weather kit thermostat
using original screws (2x).
7. If cold weather heater equipped, connect RV 12VDC input to cold
weather heater.
Note:
System should be ready to power on and test.

Power On / Test

6 6
1. Turn on refrigerator from control panel, place refrigerator in
propane mode.
Warning!
Fire and explosion hazard. To avoid fi res or
!
explosions that can cause death or destruction of property,
never use fl ames to check for propane leaks. Use an approved
soap solution that does not contain ammonia.
2. When burner lights, use approved ammonia-free soap solution to
again check for propane leaks at all fi ttings in the propane system.
Warning!
Fire and explosion hazard. If a propane leak
!
exists at the burner connection, shut down the refrigerator and
use two wrenches to loosen or tighten the leaky fi ttings—using
one wrench can damage the fi tting and create a propane leak
that could cause an explosion, death, serious injury, or dam-
age to property, now or after you complete the service.
3. If system is not free of leaks, shut down refrigerator, tighten,
repair, or replace any leaky fi ttings or tubing. Repeat leak check.
4. Confi rm drain hose (Fig.1,H) is inserted in drip cup (Fig.1,L).
Note:
Moisture collected in cup will evaporate as necessary.
Warning!
Fire and explosion hazard. Do not continue
!
until the system is completely free of propane gas leaks. A
propane leak can cause an explosion, fi re, death, serious
injury, or damage to property, now or after you complete
the service.
5. Recheck for water leaks at water valve and at water dispenser
connection.
6. If system is not free of water leaks, shut down refrigerator and
repair leaks.
7. With refrigerator free of water/propane leaks and powered on at
control panel, check for cooling in both modes of operation.
If refrigerator cools in propane, AC and DC power modes,
procedure is complete.
12
www.norcold.com