Shut Down; Disconnect Electrical; Disconnect Water Line; Fig. 1 - Refrigerator View Through Air Intake - Norcold 96 Serie Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Shut Down

1
1
D
C
A
J
K
H

Fig. 1 - Refrigerator View Through Air Intake

A. 120 VAC power cord
B. Power board
C. White 120 VAC power cord
D. +12VDC RV supply
E. 12VDC ground wire
F. Refrigerator water valve
G. RV Water Line
H. Propane supply
I. Burner
J. Rear anchor screws
K. Gas valve / bracket
L. Drip cup
B
E
L
F
J
I
G
H

Disconnect Electrical

1.1
1.1
1. Turn off refrigerator at control panel.
2. Open service access/air intake vent.
3. Unplug 120 VAC power cord (Fig.1,A) from RV receptacle AND
power board (Fig.1,B).
4. If ice maker equipped, unplug white ice maker power cord
(Fig.1,C).
Caution!
Short circuits possible. Locate 12 VDC breaker/
!
fuse for unit; then turn off unit or remove fuse. Insulate the
RV's +12 VDC supply line with electrical tape to avoid short
circuits, blown fuses or breakers.
5. Disconnect RV +12VDC (Fig.1,D) input wire from power board
terminal 12VDC (Fig.1,E).
6. Disconnect RV's 12VDC ground wire (Fig.1,E) from power board
terminal GND.
7. If cold weather heater equipped, disconnect the vehicle DC power
from the cold weather kit.
8. If cold weather heater equipped, remove the cold weather kit
thermostat (2x).
9. If cold weather heater equipped, remove the cold weather kit
heater from the cooling system. Take note of how it is wrapped
since it will be reattached to the new system.

Disconnect Water Line

1.2
1.2
Note:
Skip this step if the refrigerator is not equipped with
an ice maker.
1. Turn off water shut-off valve or RV water pump.
2. Relieve water pressure using RV sink.
Warning!
Shock hazard. Be sure AC and DC electrical
!
power to the refrigerator are turned off.
3. Disconnect the incoming water line (Fig.1,G) at the refrigerator's
water valve (Fig.1,F).
4. Disconnect the ice maker wire harness wires (white and brown
wires) from the water solenoid valve.
5. Disconnect the ice maker wire harness ground wire.
6. Move the wire harness out of the way.
7. Remove the water valve and bracket assembly (2x).
4
www.norcold.com

Publicité

Table des Matières
loading

Table des Matières