Install Fans; Connect Igniter Wire / Heaters; Install Refrigerator; Install Refrigerator Mounting Screws - Norcold 96 Serie Mode D'emploi

Install Fans

4.2 4.2
Note:
Skip this step if the refrigerator is not equipped with
a fan.
1. Place fan /bracket assembly into position and place original screws
(2x) (Fig.5,E). in fan bracket below fan. The lettering on fans faces
top of refrigerator.
2. Fasten fan thermostat switch back into place on first fin of left side
of condenser coil (Fig.4).
3. If disconnected for any reason, reconnect fan-thermostat-switch
wires to thermostat switch. Polarity does not matter.
Note:
On ice maker models if necessary, replace the cable
tie holding the wiring to the icemaker waterline.
4. Replace any cable ties that were removed.

Connect Igniter Wire / Heaters

4.3 4.3
Note:
Heaters are contained in canister located on back
right side of refrigerator.
1. If a 3-way model, install the DC heater in the cooling system.
2. Connect AC heater wires (Fig.3,D) to terminals AC_HT_LO_2 and
AC_HT_HI_2 at the power board (Fig.3,A).
3. Replace power board cover. Tighten screws (Fig.3,B).
4. Carefully reconnect igniter wire (Fig.3.C) to high voltage terminal of
power board.

Install Refrigerator

4.4 4.4
Warning!
Very heavy object. Do not attempt to remove
!
without help. Unassisted removal will likely cause bodily injury,
property damage, or both.
Note:
Make sure that all enclosure baffl es are in the correct
position.
1. With assistance, stand the refrigerator upright.
2. With assistance, push refrigerator fully back into the enclosure.
3. Reinstall any drawer or door that may have been removed from
beneath refrigerator enclosure.
www.norcold.com

Install Refrigerator Mounting Screws

4.5 4.5
1. Install the mounting screws into the upper and lower mounting
flanges of the refrigerator (4x).
2. Install the lower trim onto the front of the refrigerator (2x).
3. Install the plastic hole plugs into the upper and lower trim pieces of
the refrigerator.
4. Install screws (2x) into the mounting flanges at the rear of the
refrigerator.

Restore Power

5 5

Connect Propane

5.1 5.1
Warning!
Fire and explosion hazard. To avoid damage
!
to fi ttings and a dangerous propane leak that could
lead to death or destruction of property, always use two
wrenches to loosen and tighten the propane fi ttings. Do
not overtighten!
1. Install RV propane supply line (Fig.1,H), tighten. Do not over-
tighten!
2. Leave electrical power to refrigerator disconnected, open pro-
pane tank valve.
Warning!
Fire and explosion hazard. To avoid fi res or ex-
!
plosions that can cause death or destruction of property, never
use fl ames to check for propane leaks. Use an approved soap
solution that does not contain ammonia.
Warning!
Fire and explosion hazard. If bubbles form in the
!
soap solution, below, tighten the fi ttings or repair the fl ares. DO
NOT reconnect the electrical power until the connection is free
of leaks. A fi re or explosion resulting in serious injury, death, or
destruction of property could result!
3. Leak check fittings on both sides of gas valve and at burner using
an approved, ammonia-free soap solution. If necessary repair
leaks. Remember that with the power disconnected, only the entry
point of the gas valve can only be tested. The exit point can only
be tested after the gas valve is energized passing gas through to
the burner.
11