Do A Test Of The Gas Safety Valve; Shut Down-All Models - Norcold NX64 Manuel D'installation

- On 3-way models, the mode indicators are
(See Art02399):
- Auto mode AC electric [281]
- Auto mode gas [282]
- Auto mode DC electric [285]
- Manual mode AC electric [283]
- Manual mode gas [284]
- Manual mode DC electric [286]
- Select one of three (3) modes of operation (four (4) modes of operation on 3-way models only):
AUTO mode
MANUAL AC mode
MANUAL GAS mode
MANUAL DC mode
3. Select the temperature setting:
- Push and hold the TEMPERATURE SET button [32] to scroll through the temperature settings, one after the other (See Art02397).
- Or push and release the TEMPERATURE SET button again and again to change the temperature settings, one at a time.
- The temperature settings [278] come on as numbers in the LCD.
- Select one of nine (9) temperature settings:
- One (1) is the warmest temperature setting.
- Nine (9) is the coldest temperature setting.

Do a test of the gas safety valve:

1. Start up the refrigerator in the manual mode operation.
2. Open the lower intake vent.
3. Remove one wire from the solenoid of the gas safety valve at the rear of the refrigerator.
4. Within 30 seconds, the flame should extinguish. This means that the gas safety valve is operating correctly.
5. Put the wire back on the solenoid of the gas safety valve.
6. Close the lower intake vent.
Shut down - all models:
To shut down the refrigerator, push and hold the ON/OFF button for one second.
Installation Manual 20
281
The refrigerator's electronic controls automatically select the the most efficient energy source that
is available. Either the Auto mode AC indicator [281], the Auto mode gas indicator [282], or (on
3-way models only) the Auto mode DC indicator [285] comes on.
The refrigerator cools using only AC electric power as the power source. The Manual mode AC
indicator [283] comes on.
The refrigerator cools using only propane gas as the power source. The Manual mode gas
indicator [284] comes on.
On 3-way models only, the refrigerator cools using only DC electric power as the power source. The
Manual mode DC indicator [286] comes on.
285 282
284
283
286
Art02399